Removing Point of Measure Assigned to Sample Requests

This section describes how to remove the point of measure assigned to a sample request. Removing point of measure is used to remove the selected point of measure.


Before you begin:

Ensure that you are in the measurements page of the sample request. See Sample Request Measurement Page.

The Create Point of Measure option is available only when the following pre-conditions are met,

  • User is assigned Technical Designer role
  • Sample Request is not in Complete state.
  • Base size is selected.

  1. In the measurements page of the sample request, select the point of measures to be removed.

  2. Click Mark Selected for Removal from the page Actions menu.

  3. Refresh the page. The icon appears to indicate point of measures marked for removal.

    Note: The point of measures removed by this action are removed from the measurement chart connected to the sample request, only when the sample request is promoted to the complete state.